1-252-331-2080Get A Quote

Non-Oriented Hall Effect Sensors - HN Series

The HN series of speed sensors is based on Hall Effect sensor technology, which can sense a change in target motion from true zero to 20 KHz. These sensors incorporate a magnet within the sensor, enabling them to sense ferrous metal as well as magnetic targets. Maximum air gap sensing distances are typically 0.100".

MSI Hall Effect Sensors are optimized to provide extremely accurate tooth edge detection when used with larger pitch targets, and offer the unique advantage of not requiring orientation to the target. HN speed sensors integrate a preamplifier/signal conditioner within the sensor housing that provides excellent noise immunity and greater transmission capability.

The output frequency of these sensors has a square pulse waveform (digital) that directly relates to the number of turbine blades, gear teeth, etc. that have been sensed. These pulses, in turn, can be correlated to determine flow rate, RPM, or velocity.


Installation Considerations


Input Power

  • 4.7 to 24 Vdc regulated, 15 mA maximum @ no load
  • Reverse polarity protected

Pulse Output Options

  • TTL/CMOS (Standard); fan-out of 5
    TTL/CMOS loads
  • Open collector
  • Supply tracking:
    logic 0: 0.4 VDC
    logic 1: (VS-0.2)xRL/(RL+2200)

Airgap

  • Up to 0.100" dependent on target geometry and sensor construction

Interconnection Options

  • Three (3) pin MIL-C-5015 type connector with gold plated pins; mates with MS3106-10SL-3S; other connector types upon request
  • Pigtail with wires or cable
  • NPT threaded body with wire or cable pigtail for explosion proof environments

Warranty:

  • Unconditional one (1) year warranty if used within specifications

Pin Connections

  • Pin A (Red): Input Power (+)
  • Pin B (White): Pulse Output (+)
  • Pin C (Black): Common (-)

Physical Features:

  • Operating temperature:
    -40°C to +125°C with connector;
    -40°C to +105°C with pigtail
  • NOTE:
    units that operate up to +150°C are also available
  • Storage temperature:
    -40°C to +150°C with connector;
    -40°C to +105°C with pigtail
  • Body material:
    300 series stainless steel
  • Encapsulation:
    epoxy potting or hermetically sealed, welded construction

  • High Shock and Vibration resistance (MIL-STD-202G METHOD 214A, Test Condition H)

Orientation

  • Non-oriented operation, allowing for ease of installation

Approvals

  • CE compliant to EMC Directive 2004/108/EC for use in residential, commercial, light industrial and heavy industrial environments

Warranty

  • Unconditional one (1) year warranty if used within specifications
ATEX & IECEx Certified: Custom & Standard Speed Sensors for Intrinsically Safe applications (also approved by CSA w/NRTL/C)